![]() To do this, you will need to either tip the machine on it's back or side. If the machine still blows the GFCI, or loses power, unplug it again.How To Remove Outer Case Panels of the ECM Synchronika Espresso Machine If Yes, we recommend having the machine serviced by a tech.Try testing another appliance on the same outlet.This will require checking power coming in and back out of the control board with a meter, or sending the machine in to have it serviced by a tech. If neither of these activate the orange light, there maybe an issue with the control board of the machine. Make sure the switch on the right is pressed in towards the right side of the machine. They are for water source and heating the steam boiler. In the front of the machine behind the tray you will find two switches. If the orange light is still not on, remove the tray.Replace the water tank back into the reservoir support. If the cap is pushed down too far or has popped upward, it will change where the magnet sits and the sensor may be unable to sense the magnet. The cap that holds the magnet in place should be flush with the channel that the magnet sits in. The magnet may have come out of where it sits and would need to be put back. If it does, then inspect the magnet in the tank.Hold the magnet over that sensor and see if the orange light comes on. Standing in front of the machine and looking down at the reservoir support, there is a black sensor, on the left hand side, about halfway down. Remove the tank and have a magnet handy. ![]()
0 Comments
Leave a Reply. |